Broken CFL Glass Can Release Mercury For 128 Days: Room Mercury Air Concentrations Can Reach Toxic Levels And Be 10x Child Exposure Limits: Negative Effect On Home Sellers And Landlords

Since it seems CFLs are here to stay and incandescent light bulbs will be no more, below is an excerpt from the 3 pages of mercury clean up instructions from the EPA for cleaning up the mercury from a broken compact flourescent light bulb (CFL) in the home.

Most people do not realize that the glass of a CFL is coated with mercury and the particles of glass with continue, according to a scientific study, for up to 128 days to release mercury vapor into the air. The test ended after 43 days, but the glass fragments were still releasing mercury vapor at the end of the test and indications were that mercury would be released for another 10 to 85 days for a total of 53 to 128 days after breakage.

The same study found that a broken CFL could release toxic levels of 10 times the current recommended child air concentration exposure limit of mercury into a room.

If not cleaned up, the bulb with the largest initial store of mercury could have spewed 1 milligram of the toxic metal into a room's air within 25 days; another could have reached that level within about 40 days. Li and Jin cited data by others indicating that the release of 1 milligram of mercury vapor into a 500 cubic meter room can yield air concentrations 10 times the current recommended limit for a child. Breaking a CFL can thus cause potentially toxic levels of pollution to develop, Li and Jin conclude.[Emphasis added]

Effect On Home Buyers

You know home buyers (renters) will soon start requiring measurements of mercury vapor in rooms before purchase (renting). Sellers (landlords) will need to pay for clean-ups and home buyers (renters) will sue sellers (landlords) if there is any subsequent illness in themselves or their children that could in any way be attributed to mercury.

EPA Fluorescent Bulb Mercury Cleanup Instructions

From the 3 pages of EPA guidelines for cleaning up after a broken CFL (compact fluorescent light bulb):

Cleanup Steps for Hard Surfaces

• Carefully scoop up glass fragments and powder using stiff paper or cardboard and place debris and paper/cardboard in a glass jar with a metal lid. If a glass jar is not available, use a sealable plastic bag. (NOTE: Since a plastic bag will not prevent the mercury vapor from escaping, remove the plastic bag(s) from the home after cleanup.)
• Use sticky tape, such as duct tape, to pick up any remaining small glass fragments and powder. Place the used tape in the glass jar or plastic bag.
• Wipe the area clean with damp paper towels or disposable wet wipes. Place the towels in the glass jar or plastic bag.
• Vacuuming of hard surfaces during cleanup is not recommended unless broken glass remains after all other cleanup steps have been taken. [NOTE: It is possible that vacuuming could spread mercury containing powder or mercury vapor, although available information on this problem is limited.] If vacuuming is needed to ensure removal of all broken glass, keep the following tips in mind:
• Keep a window or door to the outdoors open;
• Vacuum the area where the bulb was broken using the vacuum hose, if available; and
• Remove the vacuum bag (or empty and wipe the canister) and seal the bag/vacuum debris, and any materials used to clean the vacuum, in a plastic bag.
• Promptly place all bulb debris and cleanup materials, including vacuum cleaner bags, outdoors in a trash container or protected area until materials can be disposed of properly.
• Check with your local or state government about disposal requirements in your area. Some states and communities require fluorescent bulbs (broken or unbroken) be taken to a local recycling center.
• Wash your hands with soap and water after disposing of the jars or plastic bags containing bulb debris and cleanup materials.
• Continue to air out the room where the bulb was broken and leave the H&AC system shut off, as practical, for several hours.

Cleanup Steps for Carpeting or Rugs

• Carefully scoop up glass fragments and powder using stiff paper or cardboard and place debris and paper/cardboard in a glass jar with a metal lid. If a glass jar is not available, use a sealable plastic bag. (NOTE: Since a plastic bag will not prevent the mercury vapor from escaping, remove the plastic bag(s) from the home after cleanup.)
• Use sticky tape, such as duct tape, to pick up any remaining small glass fragments and powder. Place the used tape in the glass jar or plastic bag.
• Vacuuming of carpeting or rugs during cleanup is not recommended unless broken glass remains after all other cleanup steps have been taken. [NOTE: It is possible that vacuuming could spread mercury containing powder or mercury vapor, although available information on this problem is limited.] If vacuuming is needed to ensure removal of all broken glass, keep the following tips in mind:
• Keep a window or door to the outdoors open;
• Vacuum the area where the bulb was broken using the vacuum hose, if available, and
• Remove the vacuum bag (or empty and wipe the canister) and seal the bag/vacuum debris, and any materials used to clean the vacuum, in a plastic bag.
• Promptly place all bulb debris and cleanup materials, including vacuum cleaner bags, outdoors in a trash container or protected area until materials can be disposed of properly.

Read the complete clean up instructions here.